Oase biOrb EARTH Notice D'emploi page 40

How to proceed:
1. Pull the power plug.
2. Remove ...
– the lamp plug,
– the cover of the filling port,
– the filter back,
– the grilles of the intake and waste air opening,
– the drain hose.
3. Pull off the casing of the back section.
4. Pull the heating cable plug.
5. Remove the two rain nozzles. To do so push the black ring in the direction of the nozzle on its
holder and simultaneously pull the nozzle forward.
6. Remove the 5 nuts with washer and a spacer sleeve.
7. Carefully and evenly pull off the back section.
Note: If the liquid reservoir contains liquid, carefully pour it out through the filling port so that
the water cannot get into the electronics.
8. Insert the supplied rubber plugs in the 7 openings created by removing the back section. This
prevents animals living in the vivarium from escaping through the holes.
9. Install a new back section and re-assemble the unit in reverse order.

When fitting the back section casing, ensure that no cables are kinked or crushed.
40