Protection Of The Environment; Connecting The Machine - Electrical Connections; Noise Information - PEUGEOT Energysaw-305DB Manuel D'utilisation

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Do not
dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for
information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the ground-water and get into the food chain, damaging your health and wellbeing. When replacing old
appliances with new once, the retailer is legally obligated to take back your old appliance for disposal at least for free of charge.
Disposal of discarded material shall be in accordance with local environmental regulations.
EXTENSION CORDS
Only use extension cords with three conductors ending in two-pin plugs and sockets with two holes and an earth pin that
are suited to the plug of the tool. When using a power tool at a considerable distance from the power source, use an exten-
sion cord heavy enough to carry the current that the tool will draw. An undersized extension cord will cause a drop in line
voltage, resulting in a loss of power and causing the motor to overheat. Use the chart provided below to determine the mini-
mum wire size required in an extension cord. Only round jacketed extension listed by laboratories should be used.
Length of extension cord: up to 15 m
Wire size: 3 x 2.5 mm2
Before using an extension cord, inspect it for loose or exposed wires and cut or worn insulation. Repair or replace any dama-
ged or worn cord immediately.
ELECTRICAL CONNECTIONS
Your machine has a precision built electric motor. It should be connected to a power supply that is 230 V, 50 Hz. If your tool
does not operate when plugged into a socket, double-check the power supply characteristics.
The noise level of the machine is measured according to standards DIN EN ISO 3744: 1995-11 and DIN EN ISO 11203: 1996-07.
The values given are emission values calculated according to applicable standards and not values relating to use in the work-
place. Although correlation between those different emission levels does exist, this cannot be reliably used to determine
whether additional precautions are necessary. Factors with potential influence on the sound emission level in the workplace
include the length of the period of work, the size of the room and any other sources of noise (e.g. number of machines opera-
ting, other noisy work being carried out at the same time). Acceptable exposure levels may vary from one country to another.
For all these reasons, we would advise users to wear equipment to protect their ears while using this machine.
Acoustic pressure level LpA:
Uncertainty:

PROTECTION OF THE ENVIRONMENT

CONNECTING THE MACHINE – ELECTRICAL CONNECTIONS

NOISE INFORMATION

101 dB (A)
1,5 dB (A)
49