Description Of The Machine; Starting Up The Machine - PEUGEOT EnergyBand-150 Manuel D'utilisation

Power supply: --------------------------------------------------------------------230 V – 50 Hz
Power: ----------------------------------------------------------------------------- 370 W
Blade rotation speed: ---------------------------------------------------------- 730 m/min
Blade dimensions: ---------------------------------------------------------------10x0.35x1820 mm
Blade width: ---------------------------------------------------------------------- 3-12 mm
Throat: ----------------------------------------------------------------------------- 245 mm
Max. cutting height: ----------------------------------------------------------- 150 mm
Table tilt angle: ------------------------------------------------------------------ 0° to 45°
Table size: ------------------------------------------------------------------------- 340 x 335 mm
Net weight: ------------------------------------------------------------------------45 kg
Gross weight: ---------------------------------------------------------------------48 kg
Check that no parts are missing from your package. When unpacking, you will find in your package:
- One band saw with blade (assembled)
- One saw table
- One fence rail for the parallel guide
- One rip fence
- One dust extractor nozzle
- One mitre fence
- One push stick
FIGURE 1: LEGEND
A. Upper housing door
B. Blade tension adjustment wheel
C. Upper door locking wheel
D. Height adjustment wheel for upper blade guide
E. Upper blade guide
F. Band saw blade
G. Saw table
H. Mitre fence
I. Fence rail for the parallel guide
J. Lower door locking wheel
K. Lower housing door
L. Band saw stand
M. Band saw base
N. Rip fence
O. On/off switch
Your band saw is delivered with a stand (L) Fig.1. Assemble the stand using 8 bolts, 8 washers and 8 nuts provided (A) Fig. 2 and position
the saw base on top. Then attach the saw base to the stand using the 8 corresponding bolts, washers and nuts (B) Fig. 2. Tighten the bolts
securely.
This machine is delivered partly assembled. Before use, the following components must be assembled:
1. saw table (G) Fig. 1
2. rip fence rail (I) Fig. 1
3. height adjustment wheel for upper blade guide (D) Fig. 1
4. belt tension adjustment wheel (B) Fig. 1
5. saw stand (L) Fig. 1
A ASSEMBLING THE PUSH STICK FASTENING SYSTEM
To better organise your workspace, you may attach the push stick (A) Fig. 3 to the saw frame when not in use.
To do this, position the push stick fastening hook (B) in the upper left corner of the saw frame, as shown in Fig. 3.
TECHNICAL SPECIFICATIONS OF THE MACHINE

DESCRIPTION OF THE MACHINE

STARTING UP THE MACHINE

21