Specifications; Unpacking And Cleaning; Important - PEUGEOT Energysaw-305DB Manuel D'utilisation

The laser class 2 warning label is on the device.
Do not remove any of the labels on the tool.
The use of measurements and procedures other than those specified here may lead to dangerous exposure to radiation.
• Never look into the laser beam.
• Do not point the laser at people or animals.
• Do not point the laser at highly reflective materials. Reflected laser light is just as dangerous.
Motor :
Speed :
Blade dimensions :
90° cross cut :
45° mitre cut, left and right :
45° bevel cut, left :
45° bevel cut, right :
Compound cut (right-hand 45° bevel and
mitre cut) :
Compound cut (left-hand 45° bevel and
mitre cut) :
Mitre stop, left and right :
Angle stop :
Laser :
Net weight :
Gross weight :
Product dimensions :
Packaging dimensions :
Your new double bevel sliding compound mitre saw is shipped complete in a box. Unpack it carefully along with all its spare
parts. Take the protective coating off all the unpainted parts. This protective coating may be removed with a soft cloth mois-
tened with WD40. Do not use acetone, petrol or paint thinner.
IMPORTANT: Do not lift the mitre saw by the operating handle as that could upset the alignments. Always lift the tool by its
base or its carrying handle if it has one.
NB: If any parts are damaged or missing, do not connect the mitre saw and do not set the switch to ON until the damaged or
missing parts have been replaced or obtained and installed correctly.
Do not dispose of the packing box before the saw is fully assembled.
IMPORTANT : While cleaning the machine after
unpacking, do not use petrol or any other petroleum-based
thinner as these products are extremely flammable. The use
of such products can lead to a risk of explosion or fire. Ge-
nerally, all the solvents used for cleaning machines are toxic
when inhaled or ingested. Always work in a well ventilated
area away from potential sources of solvents. Wear a mask.
The mitre saw is supplied with the cutting arm locked in the
transport position. To unlock the cutting arm, push it down,
pull and turn the locking knob (A) Fig. 1.
LASER RADIATION
DO NOT LOOK INTO THE BEAM
CLASS 2 LASER DEVICE

SPECIFICATIONS

2000W - 230 V AC 50Hz
5500 min¯¹
305 x 30 x 3,2 mm (60 teeth)
105 x 340 mm
105 x 240 mm
65 x 340 mm
40 x 340 mm
40 x 240 mm
65 x 240 mm
0°- 15° - 22,5° - 30° - 45° R & L
0 and 45°
Class 2
23 kg
25 kg
835 x 570 x 790 mm
915 x 570 x 535 mm

UNPACKING AND CLEANING

51
1