Faderstart; System Memory; Sleep Mode; Precautions - Omnitronic CMP-1000 Mode D'emploi

(2) Start playback of CD1. As soon as the current track of CD1 is finished, the player automatically starts
CD2. The first CD-player goes into Pause-mode. You can enter a new CD or memorize a Cue-point at
the respective player in the Pause-Mode.
(3) During the Relay-operation, the Faderstart-function is disabled. You can switch the Relay-operation off
via the Relay-button (LED off) and the Faderstart-function becomes available again.

6.11 Faderstart

With the CMP-1000, you can start the respective CD-player directly from the mixer. Make sure that the
CONTROL-sockets are connected with the respective sockets on the mixer. Additionally, the Audio Out-
sockets have to be connected with the Line-input sockets of your mixer. Please note that the Faderstart-
function only works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode).
Start playback from your mixer.
(1) Cue/Play. Please note that this selection is a Cue-point Faderstart-function. This means that the CD-
player starts playback after activating the respective channel of the mixer and goes into Pause-mode
and returns to the Cue-point after activating the channel again.
(2) Prerequisites for the Faderstart-operation: The mixer has to be connected via a 3.5 mm mono jack
with the CD-player. For starting the playback, the jack's positive pin (tip) is to be connected with the
audio mass via a short impulse. For pausing the playback, the jack's negative pin (sleeve) is to be
connected with the audio mass via a short impulse. The mixer has to be equipped with a switch, button
or fader that will connect the tip with the audio mass for starting the playback and the sleeve for pausing
the playback when the respective channel is activated.

6.12 System memory

MEMORIZING DATA
The unit can memorize all customized parameters used on a particular disc. Keep the Memory-button
pressed for one second. The blue LED turns off when the procedure is completed.
RECALLING DATA
You can recall a maximum of 2000 memorized Cue-points and loops from up to 500 CDs. To recall the
memory on a specific disc:
(1) Make sure, no CD is loaded.
(2) Press the Memory-button. The blue LED lights.
(3) Now load the respective CD. The CD source code is read and the parameters memorized before will be
loaded from the memory. The display shows "RESTORING" until the loading process is completed. The
blue LED of the Memory-button flashes and turns off.
CLEARING DATA
The system memory holds up to 2000 Cue/Loop points. To clear a full memory:
(1) Turn the unit off.
(2) Keep the Memory-button pressed and turn the unit on.
(3) The display shows "ERASING" until the clearing process is completed.

6.13 Sleep mode

If the player mechanism is set to pause for a period exceeding 15 minutes, the unit will automatically step
into sleep mode. The display indicates „SLEEP" and all illuminated buttons and all LEDs are extinguished.
Press any button, to exit sleep mode.

7. PRECAUTIONS

This CD player cannot be compared to conventional Hifi CD players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD player on plastic foam or on rubber feet in
order to avoid skipping, which is caused by vibrations of low frequencies. The same thing holds tDisque if the
CD player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
33/63 10602405_V_1_0.DOC