Operation; Turning Scale On/Off; Weighing; Settings - OHAUS Valor 1000 Série Manuel D'utilisateur

EN-8

3. OPERATION

3.1 Turning Scale On/Off

Press On/Off to turn the scale on. Then the scale displays the software version.
After the scale is turned on, long press On/Off for more than 3 seconds to turn the
scale off.

3.2 Weighing

Once the scale has a stable zero weight and the tare weight of any packaging or
container has been captured, place the product being weighed on the platform --
the display will show the weight of the product in the selected unit of measure.

4. SETTINGS

The Menu function in the scale allows several settings to be changed. Long press
Menu for 3 seconds until either
release the Menu key.
4.1 Calibration
For non-approved models, calibration is always allowed. But the Calibration menu
is locked and hidden in user memu in some regions.
To show "Calibration" in user menu, you need to enter the service menu.
- Press and hold
seconds until you see
menu.
- Short press
- Press No to change to NO.
- Press Yes to save the change.
- Short press No until you see
- Press Yes to exit the service menu.
"Calibration" is available in user menu.
Now the
Once the scale displays
calibration.
Press No to exit Calibration and to move on to next menu.
For approved models, calibration is not permitted after LFT switch is pressed
(LFT ON).
C.A.L
[ ]
and
ramMP
LOCK
No until you see
End
C.A.L
, press Yes to enter this menu to perform a
C.A.L L.I.G.H.t
or
at the same time for more than 10
. Release both keys to enter the service
. Press Yes to enter the LOCK menu.
.
TM
Valor 1000 Series
is displayed. Then