Abicor Binzel MB Mode D'emploi page 15

4 Putting into operation
4.1 Equipping the torch
1
11
10
9
1 Type 15
2 Gas diffuser
3 Contact tip
4 Tip adaptor
Fig. 1
Equipping the torch
4.2 Installing the spiral wire liner
4.2.1 Spiral wire liner
EN - 6
CAUTION
Risk of injury
Piercing or puncture caused by electrode tip.
• Do not reach into the danger zone and wear protective gloves.
Equip the torch neck according to the following figure:
2
8
5 Gas diffuser
6 Torch neck
7 Type 401/501
8 Type 401D/501D
To be used for steel wires.
1 Lay down the hose assembly straight and unscrew gas nozzle and contact
tip from torch neck.
2 Unscrew liner retention nut from central plug and slide wire liner through the
cable hose up to the liner collet.
3 Screw down liner retention nut by hand and cut off the excess length of the
spiral wire liner flush with the torch neck or the tip adaptor.
4 Unscrew liner retention nut and pull out spiral wire liner.
5 Sharpen the spiral wire liner at the front to an angle of approx. 40° and
debur the edge.
3 4 5
6
7
9 Type 24/26/36/602/240D
10 Gas nozzle
11 Type 25
MB/RAB