BFT DEIMOS ULTRA BT A 400 Instructions D'installation page 31

Logic Defnition
Confguration of
EXPI1 input on
input-output ex-
EXPI1
pansion board.
1-2
Confguration of
EXPI2 input
on input-output
EXPI2
expansion board.
1-3
Confguration of
EXPO2 output
on input-output
EXPO1
expansion board
4-5
Confguration of
EXPO2 output
on input-output
EXPO2
expansion board
6-7
TRAFFIC
Trafc light pre-
LIGHT PRE-
fashing
FLASHING.
TRAFFIC
LIGHT RED
Steadily lit red
light
LAMP ALWAYS
ON
INSTALLATION MANUAL
Cross
De- out
fault setting
used
0 Input confgured as Start E command.
1 Input confgured as Start I command.
2 Input confgured as Open command.
3 Input confgured as Close command.
4 Input confgured as Ped command.
5 Input confgured as Timer command.
6 Input confgured as Timer Pedestrian command.
7 Input confgured as Phot (photocell) safety.
8 Input confgured as Phot op safety (photocell active during opening only).
1
9 Input confgured as Phot cl safety (photocell active during closing only).
10 Input confgured as Bar safety (safety edge).
Input confgured as Phot test safety (tested photocell).
11 Input 3 (EXPI2) on input/output expansion board is switched automatically to safety device test input,
EXPFAULT1.
Input confgured as Phot op test safety (tested photocell active during opening only).
12 Input 3 (EXPI2) on input/output expansion board is switched automatically to safety device test input,
EXPFAULT1.
Input confgured as Phot cl test safety (tested photocell active during closing only).
13 Input 3 (EXPI2) on input/output expansion board is switched automatically to
safety device test input, EXPFAULT1.
Input confgured as Bar safety (tested safety edge).
14 Input 3 (EXPI2) on input/output expansion board is switched automatically to
safety device test input, EXPFAULT1.
0 Input confgured as Start E command.
1 Input confgured as Start I command.
2 Input confgured as Open command.
3 Input confgured as Close command.
4 Input confgured as Ped command.
0 5 Input confgured as Timer command.
6 Input confgured as Timer Pedestrian command.
7 Input confgured as Phot (photocell) safety.
8 Input confgured as Phot op safety (photocell active during opening only).
9 Input confgured as Phot cl safety (photocell active during closing only).
10 Input confgured as Bar safety (safety edge).
0 Output confgured as 2
1 Output confgured as SCA (gate open light).
11 2 Output confgured as Courtesy Light command.
3 Output confgured as Zone Light command.
4 Output confgured as Stair Light.
5 Output confgured as Alarm.
6 Output confgured as Flashing light.
7 Output confgured as Latch.
11 8 Output confgured as Magnetic lock.
9 Output confgured as Maintenance.
Output confgured as Flashing Light and Maintenance.
10
11 Output confgured as Trafc Light control with TLB board.
0 Pre-fashing switched of.
0
1 Red lights fash, for 3 seconds, at start of operation.
0
Red lights of when gate closed.
0
Red lights on when gate closed.
1
Optional extras
nd Radio Channel.
DEIMOS ULTRA BT A 400 - DEIMOS ULTRA BT A 600 -
31