EINHELL BT-TS 1500 Mode D'emploi D'origine page 15

Anleitung_BT_TS_1500_SPK1:_
Important.
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety instructions
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION
Read all safety regulations and instructions. Any
errors made in following the safety regulations and
instructions may result in an electric shock, fire and/or
serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout
1. Sawing table
2. Saw blade guard
3. Push stick
4. Saw blade
5. Splitter
6. Table insert
7. Parallel stop
8. Hand crank
9. Locking grip
10. Handle for setting the angle
11. ON/OFF switch
12. Eccentric lever
13. Extraction hose
14. Cross stop
15. Quick fasteners for saw blade guard
16. Extractor adapter
17. Countersunk screws (Table insert)
18. Groove (Splitter)
19. Screws (Splitter)
20. Knurled screw (Cross stop)
21. Groove (Sawing table)
22. Scale
23. Stop rail
24. Holder
25. Slot
14.05.2009 13:08 Uhr Seite 15
26. Knurled screw
27. Slot
28. Chain bar
29. Legs
30. Cross strut
31. Longitudinal struts
32. Open-ended wrench
33. Wrench
34. Rubber feet
35. Additional legs
36. Supports
37. Bench extensions
Installation material:
a Roundhead screw
b Hexagonal screw
c Nut
d Washer
e Circlip
3. Items supplied
Take all parts out of the packaging and check that
they are complete.
Bench circular saw
Saw blade guard (2)
Push stick (3)
2 x Carbide-tipped saw blade (4)
Parallel stop (7)
Extraction hose (13)
Cross stop (14)
Stop rail (23)
4 x Legs (29)
2 x Cross strut (30)
2 x Longitudinal strut (31)
Open-ended wrench (32)
Wrench (33)
4 x Rubber foot (34)
2 x additional legs (35)
4 x Support (36)
2 x Bench width extension (37)
8 x Roundhead screws (a)
24 x Hexagonal screw (b)
20 Nuts (c)
36 x Washer (d)
24 x Circlip (e)
Operating Instructions
Safety instructions
GB
15