Operating Instructions; Connecting Power; Setting Alarm 1 & Alarm 2 - Magnasonic SelfSet EAAC601 Guide De L'utilisateur

Connecting Power

The SelfSet Clock Radio is equipped with an "auto time set" feature. When
™
power is connected, the clock display will flash '2' which is TIME ZONE 2 (East-
ern time) and the default TIME ZONE setting.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to confirm your selection.
• The correct time will be displayed, unless you are in another time zone.
To change your time zone upon setup:
• Press or
ONCE to confirm your selection.
To change your time zone after setup:
• With the radio off, press and hold the
zone numbers flash.
• Press or
ONCE to confirm your selection.
There are 8 programmed times zones:
0 - Newfoundland time
1 - Atlantic time
2 - Eastern time (default)
Setting Alarm 1 & Alarm 2
Press the ALARM 1
setting and then press and hold to enter the alarm set mode. The alarm time will
flash, and the settings will appear in the following order:
HOUR > MIN > ALARM MODES > WAKE OPTIONS > RADIO VOLUME
1. Press the
or button to confirm HOUR. The MINUTES will begin to flash.
2. Press the
or button to confirm MINUTES. Alarm modes will flash.

OPERATING INSTRUCTIONS

until your own time zone appears on the display; press
until your own time zone appears on the display; press
3 - Central time
4 - Mountain time
5 - Pacific time
or ALARM 2
or buttons to decrease/increase the HOUR; press the
or buttons to decrease/increase the MINUTES; press the
button once to view the current alarm
6
button until the time
6 - Alaska time
7 - Hawaiian time
(if applicable)