Witter FT79U Instructions De Montage

MATERIALS
A 1 Cross Bar
B 1 LH Sidearm
C 1 RH Sidearm
D 6 M8 x 1.25 Nuts, Lock Washers & Washers (Grade 10.9)
E 4 Bolt Strap, M8 x 25 X 1.25 Bolt, Lock Washer, Washer & Washer Plate (Grade 10.9)
F 4 M12 x 35 x 1.75 Bolt, Lock Washers, Washers & Nuts
G 2 Existing plastic fixings
ZE 1 Electric Plate
ZN 1 Neck
FITTING
1. Remove screws from around each wheel arch and one large torx screw at the tip of the bumper. Remove the screws
from lower edge of the bumper and 2 plastic screws that are attached to the bumper crash beam. Remove the two torx
screws in the opening to the boot. Carefully pull bumper tips outwards to release from the clips attaching it to the vehicle.
Unplug any wiring connected to free the bumper.
2. Remove the crash beam. Using a knife score the mastic that runs around the face attached to back panel then remove
M8 nuts to free the beam. (Note: Additionally, ensure all mastic compound is removed to ensure a true
mating surface). Return the beam and nuts to the customer.
3. Remove tape or grommets from the bottom face of the chassis to reveal square holes. Using fixings (E), loosely attach
Sidearms (B & C) to the chassis following the instructions below. Using fixings (D) loosely attach Sidearms to the back
panel. Mastic can be used to seal the chassis openings.
4. Loosely attach the Crossbar (A) to the Sidearms using fixings (F).
5. Attach chosen neck (ZN) and Electrical Bracket (ZE).
6. Fully tighten all fixings to their correct torque setting.
7. Cut the bumper using below as a
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8 - 35Nm
Fitting
Instructions
guide. Use existing fixings (G) to attach bumper to bumper supports on Crossbar (A).
µW0001FT79U-FIT$011311010000xÄ
W0001FT79U-FIT$011311010000
For FIAT PANDA 4x4 2013 –
TREKKING –
For use with 3025 Neck Series
TOWBAR
FT79U