Proline PSO 60W-SS-E Instructions D'utilisation Et D'installation page 41

Rotisserie
Pull out the clamps on the spit by
loosening their screws and stick the spit
into chicken. Then, mount the clamps by
sliding them on the spit and stick the
clamps into chicken. Tighten their
screws. Before roasting make sure the
oven and rotisserie functions are turned
OFF. Put the tray on second shelf and
locate the rotisserie bearing bracket for
spit in the holes on the tray as shown in
the picture. Some products may have
rotisserie bearing grid accessory instead
of the rotisserie bearing bracket.
Placed on first shelf. ýn this case, you only need to place the bearing grid on third shelf.
Place the point tip of spit into hole at back panel of oven and the bearing of the spit on the
rotisserie bearing bracket or rotisserie bearing grid. Also, be sure that the tip of the spit is
placed into the hole correctly. During rotisserie, the spit handle must never be mounted and
the oven door must be closed.
NOTE: The maximum weight the spit will withstand is 4.0Kg.
Pan anti-tilting wire
Rotisserie bearing
bracket or rotisserie
bearing grid
To locate grid correctly in the cavity, put
it to any rack and push the grid fully
home.
The pan anti-tilting wire must be placed
inside of the cavitiy.
Remove G screws on
the each catalitic
enamel coated panel.
17
Spit handle Spit hole on back
panel of oven
Tray
Spit
Removal of catalitic panel