Télécharger Imprimer la page

Proline PSO 60W-SS-E Instructions D'utilisation Et D'installation page 32

Publicité

Les langues disponibles

Les langues disponibles

The dimensions and material of the cabinet in which the oven will be installed must be
correct and resistant to increases in temperature. In a correct installation, contact with
electrical or insulated parts must be prevented. Insulating parts need to be fitted in a way to
ensure that they cannot be removed by using any kind of tool. Installing the appliance in the
close vicinity of a refrigerator or a deep-freezer is not recommended. Otherwise, the
performance of the above-mentioned appliances will be negatively affected due to
emanating heat. After removing your oven from its packaging, be sure that the oven is not
harmed. In case, you suspect of any damage to the appliance, do not use it; immeditely
contact Authorized Service.
3.3. WIRING AND SAFETY
The instructions given below must be followed without fail during wiring :
The earthing cable must be connected via the screw with the earthing mark. Feeder cable
connection must be as shown in Figure 2. If there is no earthed outlet conforming to
regulations in the installation environment, call a qualified electrician to have one installed.
The earthed outlet must be in close vicinity of the appliance. Never use an extension cord.
The mains cable should not contact the product's hot surface.
In case of any damage to the mains cable, make sure to call an authorised Service. The
cable must be replaced by a qualified electrician.
Wiring of the appliance must be performed by a qualified electrician using. H05VV-F type
mains cable.
Faulty wiring may damage the appliance. Such damage will not be covered under the
warranty.
The appliance is designed to connect to 220-240V mains supply, check that the voltage on
the rating plate located inside the oven door on the right matches your local supply before
plugging in for the first time.
The Manucaturer accepts no responsibility whatsover for any kind of damage or
injury arising from not complying with safety instructions or using the wrong
mains voltage.
Figure 2
8

Publicité

loading