Exchanging Frontplate; Withdrawing And Inserting The Device; Mounting - Camille Bauer SINEAX C 402-1 Mode D'emploi

8. Exchanging frontplate

ON
(
Fig. 4. Left: Removing the transparent cover
Right: Inserting the transparent cover..
Apply gentle pressure to the transparent cover as shown in
the left side of Fig. 4 until pops out on the opposite side.
The label in the cover can be replaced and used for notes.
After replacing the label in the transparent cover, the trans-
parent cover can be snapped into the front of the device
again. This is done by inserting it behind the edge at the
bottom and pressing it gently down and to the rear with the
fi nger until it snaps into place (right side of Fig. 4).

9. Withdrawing and inserting the device

(9)
(2)
Fig. 5
Insert the withdrawing handles (2) into the openings (9) until
they snap into place. Withdraw the front part together with
the main PCB out of the housing.
To reassemble the unit, insert the front part together with the
main PCB into the housing until the swallow-tailed sections
engage in each other.

10. Mounting

The SINEAX C 402 can be mounted either on a top-hat rail
or directly onto a wall or mounting plate.
Make sure that the ambient temperature stays
within the permissible limits:
– 25 and + 55 °C for standard instruments
– 20 and + 55 °C for instruments in Ex version!
22
ON
(
ON
( (
10.1 Top-hat rail mounting
Simply clip the device onto the top-hat rail (EN 50 022)
(see Fig. 6).
Fig. 6. Mounting on top-hat rail 35 x 15 mm or 35 x 7.5 mm.
10.2 Wall mounting
Drill 2 holes in the wall or panel as shown in the drilling pattern
(Fig. 7). Now secure the power pack to the wall or panel using two
4 mm diameter screws.
Fig. 7. Drilling pattern.
The wile pressing the latch (18) in the base of the device
(Fig. 8, left), pull out the transmitter securing brackets (10).
Now secure the alarm unit to the wall or panel using two
4 mm diameter screws.
Note:
To return the brackets to their original positions, the latch (19)
in the base of the device has to be depressed before applying
pressure to the securing brackets (10) (see Fig. 8, right).
(10)
(16)
(17)
(16)
(18)
(10)
(10)
Fig. 8. Rear of device.
(10) Screw hole brackets
(16) Top-hat rail clip
(17) Rubber buffers
(19)
(18) Latch for pulling the
screw hole brackets
out
(10)
(19) Latch for pushing the
screw hole brackets in