MC Crypt X-Over 85 Notice D'emploi page 24

Connection and Control Elements
(11) Cinch connection SUB OUT
Connect your subwoofer amplifier with cinch input here.
Only one of the two outputs (XLR (10) or cinch (11)) must be connected at a time.
(12) XLR connection SAT OUT
Connect the XLR input of your satellite speaker amplifier here.
Only one of the two outputs (XLR (12) or cinch (13)) must be connected at a time.
(13) Cinch connection SAT OUT
Connect the cinch input of your satellite speaker amplifier here.
Only one of the two outputs (XLR (12) or cinch (13)) must be connected at a time.
(14) Fuse holder
Holder for the device's fuse (for fuse type, see "Technical Data").
Please observe that the fuse value depends on the device voltage set by the voltage selection
switch (15). Observe the fuse values indicated in "Technical Data".
(15) Voltage selection switch
This switch adjusts the device voltage to the local mains voltage.
Sliding the switch to the respective position makes it possible to set the operating voltage to either
110 - 120 V/60 Hz or 220 - 240 V/50 Hz.
If the voltage is selected incorrectly, the device will be damaged. Therefore, ensure before
plugging in the mains plug that the device voltage set at the active cross-over corresponds to
the available mains voltage.
Depending on the voltage value set, you may have to adjust the device fuse (on this, see
"Technical Data").
(16) Mains connection
This socket is used to supply the active cross-over with voltage. Connect the included mains cable here.
Using any unsuitable mains cables is dangerous. Therefore, use the included mains cable.
24