MC Crypt X-Over 85 Notice D'emploi page 23

Connection and Control Elements
(4) Status displays
The status display indicate the operating state of both channels.
POWER = Channel is supplied with power
SIGNAL = A signal is pending at the channel
CLIP = The channel is over-modulated (reduce the level of this signal if this display lights up)
(5) FREQ SUB control
This control sets the upper crossover frequency of the subwoofer.
Turning it clockwise increases the crossover frequency.
Turning it counter-clockwise decreases the crossover frequency.
(6) PHASE SUB switch
This switch turns the subwoofer's phase by 180° to eliminate frequency response errors caused by the
subwoofer's setup position.
(7) FREQ SAT control
This control sets the lower crossover frequency of the satellite speakers.
Turning it clockwise increases the crossover frequency.
Turning it counter-clockwise decreases the crossover frequency.
(8) XLR connection LINE IN
Connect your mixer with XLR output here.
Only one of the two inputs (XLR (8) or cinch (9)) must be connected at a time.
(9) Cinch connection LINE IN
Connect your mixer with cinch output here.
Only one of the two inputs (XLR (8) or cinch (9)) must be connected at a time.
(10) XLR connection SUB OUT
Connect your subwoofer amplifier with XLR input here.
Only one of the two outputs (XLR (10) or cinch (11)) must be connected at a time.
23