Troubleshooting Information - Dometic TEC 30D EV Manuel D'utilisation, D'entretien Et D'installation

GB
FINDING MALFUNCTIONS
The aim of the following information is to help identify and correct any malfunctions and
problems that might occur during use. Some of these problems may be solved by the
user, while for all the others specific technical knowledge or abilities are required, so that
they must only be carried out by qualified technicians of proven experience in the spe-
cific field of operation.
If the problem or fault found is not included in the irregularities noted in the table, consult
the "Alarm messages" paragraph.
Table 6: Operation failures
Problem
When the starter button is
pressed the control panel
does not light up
When the starter button is
pressed the unit does not
start
The starter motor turns,
but the unit does not start

TROUBLESHOOTING INFORMATION

Cause
Main fuse damaged
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
Safety switch in pos. 0
Battery low
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
The starter motor does not turn
Fuel level too low
The power cables are
disconnected or they do not
provide a continuous supply
The inverter is broken
Injectors dirty or faulty
Engine malfunction
Replace fuse (See
"Replacement of fuses")
Change the battery
Contact the service department
Press safety switch in order to
enable the power supply of the
equipment
Change the battery
Contact the service department
Contact the service department
Contact the service department
Fill up with fuel
Contact the service department
Contact the service department
Contact the service department
Contact the service department
- 40 - Use, maintenance and installation instructions
TEC 30D EV
Remedy