Dometic TEC 30D EV Manuel D'utilisation, D'entretien Et D'installation page 27

CONNECTING THE FUEL INDICATOR
– Only use the indicator connection if there is a fuel level probe in the tank used for the gen-
erator.
– Connect the proble cable (e.g. float) to the relevant terminal (see figure above).
CONNECTING THE BATTERY
To start the equipment, use a battery with the appropriate characteristics (see "Techni-
cal data").
Use regulation sheathed electrical cables, with the appropriate characteristics (see
"Technical data").
Proceed as indicated.
– First connect the positive cable (+) of the battery to the terminal marked with the symbol "+
" on the generator.
– Then connect the negative cable (-) of the battery to the terminal marked with the symbol
"-" on the generator.
– Protect the connections with specific grease.
– Use a fuse with the appropriate characteristics (see "Technical data") and install it in line
near the positive pole of the starter battery, in order to protect the equipment's electrical sys-
tem.
ELECTRICAL CONNECTION TO THE EXTERNAL NETWORK
Important
To use electric power from the external network, follow the instructions given below
with care.
– A relay or switch must be installed on the electric system (for instance, the Dometic switch,
code AG 102, supplied with the equipment) in order not to damage the generator when the
external power supply network is connected; in this case, connect the generator to the nor-
mally closed contacts of switch AG 102.
– The electrical connection must be made in compliance with current laws in the country of
use.
– For proper installation by the end user, it is recommended that you request the technical as-
sistance of the dealer or a specialist technician.
– For 230 V use an approved cable, whose section is shown in the table. Refer to the instruc-
tions and diagram in the following pages for the connection to the Dometic switch, code AG
102.
- 27 - Use, maintenance and installation instructions
TEC 30D EV
GB