Brandt BFU484YNW Guide D'installation Et D'utilisation page 32

③
①
②
12. Connect electrical connector① in
accordance with step 3 and then install
part②(which is in the plastic bag).
①
②upper hinge cover(right)
13.Reverse part① by 180°and install it
onto the left corner of the door， then
mount part②. (both of which are taken
down in step 2)
14. Take the reed switch out of the
coping block(part③in step 3)and mount
it on another block for use (which is
with mark "L" in the plastic bag). Put the
coping block just removed back to the
plastic bag.
Note： Be sure character side of
reed switch fits well with coping block.
15.
connector② , and then install part③ .
XXXXXXXXXXXXXXXXXXXXXXXX
29
1
2
Install part ①
, connect the wire