Brandt BFU484YNW Guide D'installation Et D'utilisation page 30

Reversing the door
The side at which the door opens can
be changed, from the left side (as
supplied) to the right side, if the
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket wrench
Cross-shaped screwdriver
Thin-blade screwdriver
Note: Before you start lay the
freezer
on its back in order to
gain access to the base, you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright.
8mm wrench
freezer
. To
Hisense Refrigerator
XXXXXXXXXXXXXXXXXXXXXXXX
2. Open part ①
freezer
body from left side and then
take down part ③ and part ④ on the
door in the same way. Take down part
② and put it back to the plastic bag.
①Upper cover
②Upper hinge cover (left)
③Upper cover of upper door
④Corner cover
1
2
3. Disconnect electrical connector① as
well as electrical connector② and then
take down part③.
4. Remove the screws ① , loose
wire②, and remove part③.
27
on top of the
3
1
2
3