Simple Reset; Complete Reset - Häfele FT 200 Instructions D'utilisation

12. Reset

12.1 Simple reset

A simple reset is required to configure the FT 200 / FT 200 CAP furniture terminal with the
MDU 110 data transfer unit.
Prerequisites:
1. Press the reset button.

A brief acoustic signal is heard.

12.2 Complete reset

A complete reset is required after losing the programming or clearing key card. The system
then has to be reconfigured
A complete reset clears all data on the programming and clearing key card as well as the
locking authorisations for the user keys. The factory settings of the FT 200 / FT 200 CAP
furniture terminal are restored.
Prerequisites:
1. Press the reset button.

A brief acoustic signal is heard.
A tool to actuate the reset button, such as a thin pen/pencil or
opened out paper clip
< 1s
2. Press and hold the reset button until a long
acoustic signal is heard.


6. Start-up.
A tool to actuate the reset button, such as a thin pen/pencil or
opened out paper clip
< 1s
2. Press and hold the reset button until two long
acoustic signals are heard.

The lock on parametrisation with the
MDU 110 data transfer unit is disabled.
All data and access rights are cleared.
> 1s
2x > 1s
39