Publicité
Les langues disponibles
Les langues disponibles
EN
similarly qualified person in order to avoid a
hazard.
Transport damage
Your Poolrunner was packed carefully for the
transport.
Please ensure when taking over
that the packaging is in an undamaged
condition and all parts are in the package. If
you have ordered the package by mail, make
sure that the delivery is complete. Transport
damage must immediately be reported to the
carrier (transport company or parcel). The
responsibility for damages during transit is
the
transporter,
responsible.
Warranty
Warranty in relation to operation safety and
reliability
is
only
manufacturer under the following conditions:
The pool cleaner is operated according
!
to the specifications of the user.
!
For repairs, only original spare parts
are used (wearing parts are not subject
to warranty).
Consequential damages
For damage to the product, caused by failure
to follow the manuel recommendations, we
can not
pay.
Position the power supply
The power supply of the device should be
appropriately positioned to allow the cleaner
to reach all corners of the basin.
avoid any accident/damage, the power supply
unit should be steadily placed and fixed at a
minimum distance of 3.5m from the pool
edge.
Specifications:
• Input voltage: 230 VAC
• Frequency: 50 Hz
• Output voltage: DC (direct current) 24 V
• Input power: 150 W
• Output power: 120 W
• Working cycle: 1 h. / 1,5 h. / 2 h. / 2,5 h.
• Cable lenght: 12 m
• Maximum cleaning area in the swimming pool: 100 ㎡
Poolrunner | 2016_V1
the
supplier
is
accepted
from
In order to
• Filtering capacity: 15 m³/h
• Filtering capablity: 150 µm
Working temperature (water):
•
• Creeping speed: 15 - 18 m/min
Water resistance class: Cleaner: IPX8, power control box: IPX4
•
• Ambient temperatur: 10°C - 40°C
Cleaner Structure, Figure 1
Connecting cable, Figure 2,3,4
not
Description of control panel, Figure 5
Item
Name
1
ON/OFF
the
2
CYCLE
3
LED
Function of jet propulsion, Figure 6
Each on the front and on the back of the cleaner there are two
adjustable control nozzles for the drive in the water. The sucked foul
water is first cleaned through the filter bag and then used for the
drive for the cleaner above the thrusters. The nozzles are adjustable,
depending on the size and pool type, to achieve the best cleaning
effect.
Recommended nozzle settings:
High speed / less cleaning (with low pollution)
•
Slow speed / high cleaning efficiency (moderate to heavy
•
contamination)
Figure 11,12,13
The above are recommending settings and operator can select a
proper nozzle direction based on above principle actual pool situa-
tion.
Commissioning
Since you have made your settings, you can put the cleaner
carefully and slowly into the pool. Please refer to the following
pictures as the cleaner may be best placed in the pool.
14,15,16
The cleaner must always be committed or removed to the pool that
the underside of the cleaner facing the pool wall, to avoid possible
scratches on the pool surface.
IMPORTANT! Figure 19,20
10°C - 32°C
Function
Detail
Power on or off
Power on or
off
Stop after 1 hour
working, fit for small
swimming pool
Stop after 1.5 hour
working, fit for me-
dium
pool
Stop after 2 hour
working, fit for large
swimming pool
Flash
ponding cycle, all
indicators flash after
one cycle finish.
Figure 7,8,9,10
Figure 17,18
Page 7 of 50
swimming
by
corres-
Figure
Publicité
