Star SP312F Guide D'installation page 27

DIP Switch Setting
Each of the switches in the DIP switch array is factory preset to the "ON" position.
Be sure to turn the power for both the printer and host computer off before
changing the setting of the DIP switches.
DIP-SW 1
Switch
1-1
(Not used)
1-2
1-3 Control code CR
1-4 When turning
*1 the power on.
1-5 Setting the paper feed length
1-6 Setting the buffer size
1-7 Backed up RAM
1-8 Paper out detection function
*1 If you use a parallel interface printer, Switch 1-4 is used for switching the auto
cutting control mode. For details, see Switch 3-4 described on the following
page. (SP342)
*2 The addressable mode is valid only when the optional RS-422A serial
interface is mounted.
APPENDIX
DIP switch array
Function
DC1, DC 3
mode
Addressable
mode *2
– 25 –
ON
Invalid Valid
Select Deselect
Deselect Select
1/6-inch 1/8-inch
4 K-bytes 256 bytes
YES NO
Valid Invalid
OFF