Select And Start A Washing Programme - BORETTI BVW 96 Notice D'utilisation

6. To deactivate the rinse aid dispenser
again, follow the above instructions until
the End indicator light goes off.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the on/off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme. The indicator light of
the selected programme comes on. Re-
fer to 'Washing programmes' for more
details.
Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the indicator light corresponding to the
chosen hours flashes (3h, 6h or 9h).
– The delay start indicator light comes
on.
2. Close the appliance door, the countdown
starts automatically.
3. The countdown will decrease with steps
of 3 hours.
4. Once the delay start has elapsed the pro-
gramme will start automatically.
– The delay start indicator light goes off.
The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
The appliance will automatically stop and an
audible signal informs you of the end of the
washing programme.
1. Open the appliance door.
– The end of programme indicator light is
on.
– The indicator light of the programme
just ended remains on.
2. Switch of the appliance.
3. Leave the appliance door ajar for a few
minutes before removing the dishes. In
this way they will be cooler and the drying
will be improved.
83