Use Of Dishwasher Salt - BORETTI BVW 96 Notice D'utilisation

76
Water hardness
°dH
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The appliance is factory set at level 5.
1. Press the on/off button. The appliance
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A, B and C start flashing.
3. Press function button A
– the lights of function buttons B and C
go off,

Use of dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
°TH mmol/l
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
Adjusting the water hardness setting
manually
2
2
2
2
1
1
1
1
– the light of function button A continues
to flash,
– at the same time the end of pro-
gramme indicator light starts to flash,
– a sequence of intermittent audible sig-
nals are heard.
The current level is indicated by the num-
ber of flashes of the end of programme
indicator light and of the intermittent au-
dible signals.
Examples:
– 5 flashes / 5 intermittent audible signals
- pause - 5 flashes / 5 intermittent au-
dible signals - pause, etc. = level 5
– 6 flashes / 6 intermittent audible signals
- pause - 6 flashes / 6 intermittent au-
dible signals - pause, etc. = level 6
4. To change the level, press function but-
ton A. Each time the button is pressed the
level changes. (For the selection of the
new level refer to the chart).
Examples:
– If the current level is 5, by pressing
function button A once, level 6 is se-
lected,
– if the current level is 10, by pressing
function button A once, level 1 is se-
lected.
5. To memorize the operation, switch off the
appliance.
ener. Only fill with salt just before starting one
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
Use of
electronically
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
salt
yes
yes
yes
yes
yes
yes
yes
no