Multitab Function; Setting And Starting A Washing Programme - BORETTI BVW88 Notice D'utilisation

32
Different brands of detergent dissolve in
different times. Some detergent tablets
do not have the best cleaning results
during short washing programmes. Use

Multitab function

The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are applicable for
the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function stops automatically the
flow of rinse aid and salt. The rinse aid indi-
cator light and salt indicator light are deacti-
vated.
The programme duration can increase if you
use the multitab function.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
• Press the multitab button. The multitab in-
dicator light comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab in-
dicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.

Setting and starting a washing programme

Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
All manuals and user guides at all-guides.com
long washing programmes when you
use detergent tablets to fully remove the
detergent.
To activate/deactivate the rinse aid dispens-
er:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
– The digital display shows the setting.
6. Press function button B again.
– The digital display shows the new set-
ting.
7. Switch off the appliance to save the op-
eration.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated