Working With The Chainsaw Mounting Kit - Pattfield Ergo Tools PE-AHE 18 Li Traduction De La Notice Originale

7. Working with the chainsaw mounting kit

Preparations
To ensure that you can work safely, check the following points before
every use:
Condition of the chainsaw
Inspect the chainsaw before the start of work for damage to the
housing, the power cable, the saw chain and the cutter rail. Never use
a chainsaw which is obviously damaged.
Oil container
Fill level of the oil container. Even while working, keep checking that
suffi cient oil is in the system. To avoid damaging the chainsaw, never
run the saw if there is no oil in the system or if the oil drops below the
"min" mark. On average, a single fi lling will last around 20 minutes de-
pending on the number of pauses in cutting and the loads involved.
Saw chain
Tension of the saw chain, condition of the cutting ele-ments. The
GB
sharper the chainsaw, the easier and more controllable it is to ope-
rate the chainsaw. The same also applies to the chain tension. Also
while working you should check the chain tension no less than every
10 minutes in order to increase your safety. New saw chains in parti-
cular often tend to expand more.
Safety clothing
Always wear appropriate tight-fi tting safety clothing like special
trousers which protect against cuts, protective gloves and safety
shoes.
Anl_PE_AHE_18_Li_Basic_SPK7.indb 364 Anl_PE_AHE_18_Li_Basic_SPK7.indb 364
- 364 -
15.01.16 13:09 15.01.16 13:09