Pattfield Ergo Tools PE-AHE 18 Li Traduction De La Notice Originale page 362

5.10 Adjusting the telescopic tube (Fig. 21)
1. Undo the telescopic tube lock nuts (10 + 12) by turning them
counter-clockwise.
2. Pull out the telescopic tubes (11 + 13) to suit the required working
height.
3. Secure the telescopic tube lock nuts (10 + 12) by them turning
clockwise.
5.11 Fitting the battery (Fig. 22 – 23)
Press the side pushlock button (T) of the battery pack as shown in
Fig. 22 and push the battery pack into the mount provided. When the
battery pack is positioned as in Fig. 23, make sure that the pushlock
button latches in place! To remove the battery pack, proceed in rever-
se order.
5.12 Charging the battery (Fig. 24)
1. Take the battery pack out of the equipment. Do this by pressing
the pushlock button (T).
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. Insert the power plug of the
GB
charger (21) into the mains socket outlet. The green LED will then
begin to fl ash.
3. Insert the battery pack (1) into the battery charger (21).
4. In the section entitled „Charger indicator" you will fi nd a table with
an explanation of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This
is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging contacts.
Anl_PE_AHE_18_Li_Basic_SPK7.indb 362 Anl_PE_AHE_18_Li_Basic_SPK7.indb 362
- 362 -
15.01.16 13:09 15.01.16 13:09