Function - Franke 7612982130793 Notice De Montage

☞
It can take a few minutes until the "do NOT PAY" display goes out depending on the
number of Aquapay fittings.
• The number of Aquapay fittings recognised by the coin-activated switch is shown
on the display.
12.7 Put the jumper (b) over the two lower pins when the displayed number corresponds
to the existing number.
• The Aquapay module sends the Aquapay fittings a command for sensor
addressing and switches to identification mode.
12.8 When a "1" is shown on the display, trigger the shower that is to be assigned to
shower unit 1.
12.9 When a "2" is shown on the display, trigger the shower that is to be assigned to
shower unit 2.
12.10 Repeat this procedure until all showers are assigned a shower number.
• The configuration is saved in the Aquapay-module when all Aquapay fittings are
addressed.
• "XXX" is shown on the display.
• The coin-activated switch is in normal operating mode after saving.

13. Function

13.1 The next free shower unit is shown on the display (a).
• Display: Pay X
13.2 If the free shower unit displayed is not the one you want, select another free shower
unit using the (b) button.
13.3 Insert the coins in the coin tester (c).
• The flow duration is displayed.
13.4 10 s after the last coin was inserted, "GO X" appears on the display.
• The time account is transferred to the shower.
• The shower is enabled.
Option to switch over to unpaid water delivery
13.5 Push up the switch (d) on the Aquapay module (e).
• "do NOT PAY" is shown on the display.
- 8 -