Reely DIY X-79 Mode D'emploi page 27

6 Select the suitable rotors A/B and press them onto the respectivemotor shafts. It is
imperative that you leave a small distance between the rotor and the motor housing.
The components must not grind against one another in operation. If the rotors are
mounted incorrectly or have been permanently damaged, they can be removed from
the motor shaft with the enclosed tool. Insert the tool between the propeller and the
motor housing as a lever.
7 Optionally, depending on model: Connect the camera contacts to the main board from
above. Attach the camera to the cover cap. Manually move all of the rotors to check
whether any are in contact with the camera. Also note the camera's antenna.
8 Slide the (charged) flight battery into the holder provided under thedrone.
9 Connect the flight battery contacts and board contacts for operation.
27