Simer 220515H Guide D'utilisation page 11

Preparing to Start the Deep Well Pump
Remove pressure
regulator and fill
pump and
suction piping
through pump
discharge port.
Figure 13: Fill Pump
Replace pressure
regulator and all fill
plugs, reconnect the
hose, and close
the regulator
Figure 14: Prime Pump
A-SLOWLY open Pressure Regulator
B-Watch for Gauge to Flutter or Drop
C-Close Pressure Regulator until Pressure
Stabilizes
5979 0309
Figure 15: Set Control Valve
For parts or assistance, call Simer Customer Service at 1-800-468-7867
pump to overheat, damaging seal and possibly causing burns to persons
handling pump. Fill pump with water before starting.
water inside pump, causing hazardous pressure in unit, risk of explosion
and possibly scalding persons handling pump.
Step 1. Open the pressure regulator as far as possible without backing it
out of the regulator body. Then remove the regulator from the pump
and fill the pump, fill all piping between the pump and the well,
and make sure that all piping in the well is full. If you have also
installed a priming tee in the suction piping, remove the plug from
the tee and fill the suction piping (see Figure 13).
Step 2. Replace all fill plugs and close the pressure regulator completely
(Figure 14).
Step 3. Power on! Start the pump and watch the pressure gauge. The
pressure should build rapidly to about 50 PSI as the pump primes.
5977 0309
Step 4. After 2 or 3 minutes, the gauge should show pressure. If not, stop
the pump, remove the fill plugs, reopen the control valve, and refill
the pump and piping. You may have to repeat this two or three
times in order to get all the trapped air out of the piping. Don't for-
get to close the control valve each time before you start the pump.
Step 5. When pressure has built up and stabilized at about 50 PSI, slowly
completely
open the control valve (see Figure 15) and let the pressure drop
until the pressure gauge needle starts to flutter or drops to 0. When
the needle flutters or drops, close the valve just enough to stop the
flutter or bring the needle back to a stable pressure (see Figure 15).
Your pump is now operating at its most efficient point.
Step 6. After the pump has built up pressure in the system and shut off,
5978 0309
check the pressure switch operation by opening a faucet or two
and running enough water out to bleed off pressure until the pump
starts. The pump should start when pressure drops to 30 PSI and
stop when pressure reaches 50 PSI. Run the pump through one or
two complete cycles to verify correct operation. This will also help
clean the system of dirt and scale dislodged during installation.
Congratulations on a successful installation.
If you were unsuccessful, please refer to the Troubleshooting section or call
our customer service technical staff.
Never run pump dry . Running pump without water may cause
Never run pump against closed discharge . To do so can boil
11