Switch-Off After 10 Minutes Of Continuous Operation (Trig Function) - VOLTCRAFT IR 800-20C Notice D'emploi

Proceed as follows to set and activate the upper alarm value (H = High):
• Hold the MODE button for approx. 1 second to access the setup menu.
• Press the MODE button until the display flashes the alarm symbol and the letter H for the
upper limit value.
• Press the ▲ or ▼ button to change the value.
• Press the laser/backlight button to activate (ON) or deactivate (OFF) the alarm.
• Press the measuring button to confirm your input or press the MODE button to proceed to
the next setting.
• When the device is switched off, the set value is retained.
Proceed as follows to set and activate the lower alarm value (L = Low):
• Hold the MODE button for approx. 1 second to access the setup menu.
• Press the MODE button until the display flashes the alarm symbol and the letter L for the
lower limit value.
• Press the ▲ or ▼ button to change the value.
• Press the laser/backlight button to activate (ON) or deactivate (OFF) the alarm.
• Press the measuring button or MODE to confirm your input.
• When the device is switched off, the set value is retained.
d) Switch-off after 10 minutes of continuous operation (TRIG
function)
If you use the TRIG function, the product switches off automatically when the measuring button
is pressed for longer than 10 minutes without interruption. This prevents unwanted continuous
measurement if, for example, the measuring button is pressed accidentally.
• Hold the MODE button for approx. 1 second to access the setup menu.
• Press the MODE button until TRIG flashes on the display.
• Press the laser/backlight button to activate (ON) or deactivate (OFF) the function.
35