Presetting Receiver; Operation - VOLTCRAFT MS-575 Mode D'emploi

1. The charging status warning (8) REMOTE will be displayed on the receiver's monitor when the
transmitter's batteries need replacement.
2. Open the battery compartment (29).
3. Insert 2 AAA batteries, observing the correct polarity.
4. Push the reset button (26) using a suitable tool.
5. Close the battery compartment (29) again.
8.

PrESETTinG rEcEiVEr

The reset switch (16), the ºC / ºF toggle switch (17) and the HI / LOW toggle switch (19) are
located under the receiver's battery cover.
1. Open the receiver's battery compartment (18) by lifting the battery compartment lock (20) up and
lifting the battery cover off.
2. Set the temperature by switching the ºC / ºF toggle switch (17) to ºC (Celsius) or ºF (Fahrenheit).
3. Set the volume of the voice output by switching the HI / LOW toggle switch (19) to HI (loud) or
LOW.
9.

oPErATion

1. Plug the temperature probe's plug into the connector for the temperature cable (28) on the
transmitter.
2. Press the power button (27) on the transmitter:
- The LED will flash, indicating that the transmitter is turned on.
3. Press the power button (2) on the receiver:
- The signal strength indicator (9) on the receiver will turn on when the transmitter has been
automatically recognised. It indicates how strong the signal reception is:
Signal:
Icon:
- The temperature (13) is displayed.
First, place the transmitter close to the receiver until it has been recognised. The maximum
range is 100 m.
If the receiver does not recognise the transmitter, open the battery compartments (18 / 29) of
both devices and press the reset buttons (16 / 26). Close the battery compartments (18 / 29)
and turn both devices back on.
When the receiver is moved out of the transmitter's range, it will beep three times as a
warning.
strong weak out of range
21