EINHELL BT-MG 135/1 Mode D'emploi D'origine page 19

7.8. Accessories (Fig. 14 / Fig. 1; Item 4/6/10)
1 Arbor for felt wheels
2 Arbor for grinding wheels
3 Felt polishing wheel
4 Felt polishing wheel
5 Grinding wheel
7.9. Accessories (Fig. 15 / Fig. 1; Item 7)
1-6 Drill bits (1-3 mm)
7.10. Description of the accessories:
Cutting disks:
For cutting metal and plastic.
Insert the cutting wheel onto the clamping spind-
le.
Grinding pins:
In various grinding head shapes.
For grinding and deburring metal and plastic.
HSS bits:
For drilling work on non-ferrous metals, wood,
plastic and printed circuit-boards.
Grinding wheels:
For cleaning and sharpening blades and tools. In-
sert the grinding wheel onto the clamping spindle.
Grinding paper:
For grinding and deburring wood and plastic.
Polishing wheels / polishing pins:
For polishing brass, tin, copper, etc. Also for use
with polishing pastes.
Wire brushes:
For cleaning stone, metal, aluminium, etc.
Grinding belts:
For grinding word and plastic.
Diamond cutting wheel:
For cutting, separating, grinding and deburring
materials, such as concrete, stone, china, cera-
mic, etc.
Sleeves:
Various sizes for mounting diff erent accessory
tools.
Cutters:
For cutting plastic, wood and soft metal
Anleitung_BT_MG_135_1_SPK1.indb 19 Anleitung_BT_MG_135_1_SPK1.indb 19
GB
Collet chuck key
For mounting accessory tools
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment. En-
sure that no water can seep into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 19 -
26.09.11 11:04 26.09.11 11:04