EINHELL BT-MG 135/1 Mode D'emploi D'origine page 16

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
2. Layout and items supplied
2.1 Layout (Fig. 3)
1 On/Off switch
2 Speed controller
3 Clamp nut
4 Locking knob for collet chuck
5 Cover
2.2 Items supplied (Fig. 1/2/3)
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anleitung_BT_MG_135_1_SPK1.indb 16 Anleitung_BT_MG_135_1_SPK1.indb 16
GB
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Case
•
Grinding disks
•
Grinding belts
•
Clamping spindles
•
Cutters
•
Felt polishers / arbors
•
Drill bits
•
Drive unit
•
Grinding pins
•
Grinding disks
•
Clamping sleeves
•
Cutting wheels
•
Flexible shaft
•
Table clamp
•
Telescopic stand rod
•
Grinding heads
•
Wire brushes
•
Original operating instructions
•
Safety instructions
3. Proper use
The Grinding and Engraving Set is designed to
perform drilling, grinding, deburring, polishing,
engraving, cutting, milling and cleaning jobs
on wood, metal and plastic in model-making,
workshop and household applications. Use the
tool and accessories only for those applications
described.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
- 16 -
26.09.11 11:04 26.09.11 11:04