Publicité
Les langues disponibles
Les langues disponibles
Electrical connection,
see illustration on page 3:
Install relay (Hella part No.12 V:
4RA 003 510-361 or 24 V: 4RA 003
510-651) with connection terminals
pointing downwards so that they
are protected against splashing
water.
Final installation,
see illustration on page 4:
Fig. 4: Screw lamps to vehicle (use
two-point mount if required).
Fig. 5: Align lamps and tighten
screws.
Reconnect earth lead (-) to battery.
Check lights, tighten connection
wires securely.
Fig. 6: Only on special versions with
mount, page 5, Fig. A.
9
If required, install switch in
dashboard..
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according
to circuit diagram (page 3).
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.
The use of the enclosed cover is
not permissible in areas governed
by German Traffic Laws, However
it is permissible to use protective
grilles.
According to circuit diagram
auxiliary lamps are switched on
together with the existing main
beams.
According to circuit diagram
auxiliary lamps can be switched on
in addition to the main beams with
a separate switch.
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80% of the light.
You drive more safely when you
can see and be seen well.
Do you have spare bulbs and
fuses in your vehicle?
If you have any questions or
installation problems: Contact
your Hella stockist.
I
the
II
the
Publicité
