8. Care and maintenance
Danger!
Remove the battery pack before doing any cleaning and mainte-
nance work.
•
Always keep the tool clean and dry and protect it from oil and gre-
ase.
•
Wear safety goggles to protect your eyes during cleaning.
•
Always keep the tool and the air vents clean in order to ensure
safe and correct use.
•
Check the ventilation grilles at the motor and at the On/Off switch
for dust and foreign bodies. Remove layers of dust with a soft
brush.
•
If required, use a soft damp rag to wipe the tool housing clean.
You can use a mild cleaning agent but no alcohol, petrol or other
cleaning agent.
•
Never use aggressive cleaning agents to clean plastic parts.
•
Lubricate all moving parts regularly.
•
Check all fasteners regularly. Vibrations might cause fasteners to
become loose in the course of time.
•
The cutters should be cleaned and lubricated at regular intervals
in order to ensure best performance at all times. Remove deposits
with a brush and apply a thin film of oil (Fig. 22).
9. Faults
The device does not operate:
Check that the battery is charged and whether the charging unit is
working. If the equipment will not work in spite of the voltage supply
being OK, please take it to your Hornbach store.
Anl_PE_AHH_18_Li_Basic_SPK7.indb 279
Anl_PE_AHH_18_Li_Basic_SPK7.indb 279
- 279 -
GB
15.01.16 13:02
15.01.16 13:02