Pattfield Ergo Tools PE-AHH 18 Li Traduction De La Notice Originale page 276

5.6 Adjusting the angle of the handle (Fig. 11)
Press the two safety lock-off s (5) and adjust the angle of the handle
(2) to any of 4 latching positions.
5.7 Adjusting the angle of the motor housing (Fig. 12)
Press the two safety lock-off s (14) and adjust the angle of the motor
housing (13a) to any of 7 latching positions.
5.8 Adjusting the telescopic tube (Fig. 13)
1. Undo the telescopic tube lock nuts (10 + 12) by turning them
counter-clockwise.
2. Pull out the telescopic tubes (11 + 13) to suit the required working
height.
3. Secure the telescopic tube lock nuts (10 + 12) by them turning
clockwise.
5.9 Fitting the battery (Fig. 14-15)
Press the side pushlock button (T) of the battery pack as shown in
Fig. 14 and push the battery pack into the mount provided. When the
battery pack is positioned as in Fig. 15, make sure that the pushlock
GB
button latches in place! To remove the battery pack, proceed in rever-
se order.
5.10 Charging the battery (Fig. 16)
1. Take the battery pack out of the equipment. Do this by pressing
the pushlock button (T).
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. Insert the power plug of the
charger (21) into the mains socket outlet. The green LED will then
begin to fl ash.
3. Insert the battery pack (1) into the battery charger (21).
4. In the section entitled „Charger indicator" you will fi nd a table with
an explanation of the LED indicator on the charger.
Anl_PE_AHH_18_Li_Basic_SPK7.indb 276 Anl_PE_AHH_18_Li_Basic_SPK7.indb 276
- 276 -
15.01.16 13:02 15.01.16 13:02