5.3 Removing the hedge trimmer mounting kit from the motor
head (Fig. 5-6)
The guard must be slipped over the hedge cutter blade in order to
prevent injuries.
1. Pull the lock button (R) to the right.
2. Turn the hedge trimmer mounting kit to the point where the arrows
on the motor head and hedge trimmer mounting kit coincide, al-
lowing the mounting kit to be removed.
5.4 Adjusting the additional handle (Fig. 7-8)
a) Setting the tilt of the additional handle
Open (a) the lock (F). Set the desired tilt of the additional handle (9).
Close (b) the lock (F).
b) Shifting the additional handle
Open (a) the lock (H) and slide the additional handle (9) into the re-
quired position. Close (b) the lock (H).
5.5 Using the shoulder strap
Warning! Always use the shoulder strap when working with the
equipment. Switch off the equipment before you take off the shoulder
strap (risk of injury).
1. Hook the carabiner (Fig. 4/Item A) into the strap holder.
2. Slip the shoulder strap (Fig. 9/Item 8) over your shoulder.
3. Adjust the length of the shoulder strap so that the strap attach-
ment is at waist level (Fig. 9).
4. The shoulder strap is equipped with a buckle. Press the hooks
together (Fig. 10) if you need to put down the equipment quickly.
5. To change the strap position on the equipment, press together
the two metal loops (Fig. 4/Item L / M) and adjust the strap attach-
ment on the tube.
Anl_PE_AHH_18_Li_Basic_SPK7.indb 275
Anl_PE_AHH_18_Li_Basic_SPK7.indb 275
- 275 -
GB
15.01.16 13:02
15.01.16 13:02