Chicco Hoopla Mode D'emploi page 12

other objects could be used by the
child to climb or causing chocking
or strangling hazards.
• D o not place the chair near windows
or walls to prevent the risk for the
child of overreaching and falling over.
• D o not attach any strings to extend
the fastening systems of the toy-
bar' s hanging toy and do not make
knots/ loops: This could lead to run-
ning knots from accidentally forming
which could lead to strangulation.
• WARNING: This toy must only be
used under adult supervision.
• WARNING: Check the toy regularly
for signs of wear and damage and
to ensure that it is assembled cor-
rectly. Should any parts on the toy-
bar or hanging toy be damaged,
do not use them and keep out of
reach of children.
• K eep the product out of children's
reach when it is not being used.
CARE AND MAINTENANCE
FABRIC COMPOSITION
COVER:
Outer cover: 100% polyester. Padding: 100% polyester.
BOOSTER CUSHION:
Outer cover: 100% Polyester. Padding: 100% Polyester.
• T his product requires periodical maintenance.
• T he cleaning and maintenance operations must only be carried
out by an adult.
• P eriodically inspect the reclined cradle to check for broken, torn or
missing parts: If this is the case, do not use it.
• P lease refer to the care label for instructions on cleaning the product.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
• C heck that the fabric and stitching are in good condition each
time you wash it.
• P rolonged exposure to direct sunlight can cause the fabric to fade.
COMPONENTS
A - Base
B - Feet
B1 - Non-slip rubber
B2 - Open/close buttons
C - Seat
D - Booster cushion
DD - Headrest
E - Toybar
F - Slider ring
G - Toys*
H - Toybar coupling holes
I - Fabric handles
L - Safety harness
M - Buckles
N - Clips
O - Ring for the adjustment of the safety harness
P - Reclining button
Q - Click buttons
R - Seat buttonhole
ASSEMBLY
The reclined cradle comes already assembled. To use it, the follow-
ing operations must be performed:
1. T o open the reclined cradle pull the seat upward (Fig. 1), when
you hear it click, it means the product is correctly opened. Make
sure that both sides of the reclined cradle are properly open.
2. F asten the toybar on both sides by fitting the lower ends of the
bar into the relevant coupling holes (Fig. 2).
At this point you can choose the position you prefer.
HOW TO ADJUST THE BACKREST
3. T o adjust the backrest from a higher position to a more inclined
one, take the two side buttons (Fig. 3) and pull them upward,
keeping them pressed down; choose the desired reclining within
the 4 available positions. This operation may also be carried out
with the child sitting in the reclined cradle. In this case it can be
more difficult.
WARNING: Always guide the backrest with the fingers when adjust-
ing the reclining.
To move from the highest inclined position to a lower inclination,
just pull the backrest upward (Fig. 4-5).
WARNING: Always check that the backrest is properly locked before use.
The reclined cradle is equipped with transport handles made of
fabric.
WARNING: The transport handles (I), when not used, shall be fixed on
the back of the backrest with the velcro ribbons.
FIXED OR ROCKING MODE
4. The reclined cradle can be used in fixed or rocking mode:
• F ixed mode: turn the front feet (B) clockwise until the lower part of
the foot touches the ground (Fig. 6);
• R ocking mode: turn the front feet (B) in the opposite direction (coun-
ter-clockwise), so that the foot is not touching the ground (Fig. 7).
HOW TO CLOSE THE CHAIR
5. The reclined cradle can be closed for transport.
WARNING: The reclined cradle must never be closed with the child
sitting in it. Remove the child from the reclined cradle before clos-
ing the frame!
6. T o close the reclined cradle, press the 2 buttons inside the front
feet (Fig. 8) simultaneously.
7. T o open the reclined cradle again, just pull the seat upward (Fig. 9)
until you hear a click that indicates the correct opening.
USING THE SAFETY HARNESS
8. T he safety harness is pre-fitted and ready for use the first time you
use the reclined cradle (Fig. 10).
To release it, press the toothed ends of the clasp and remove the two
clasps (Fig. 11). The bouncer is ready for the child.
WARNING: When using, always remember to fasten the belt by pass-
ing it around the crotch strap and check it is tight enough and in
the right position.
It is possible to alter the tightness of the belt by adjusting it and pass-
ing the fabric around the back of the backrest.
9. K eep one clasp end blocked and simultaneously pull the belt
and slide it inside the relative ring (O), to adjust the tension of the
12
s
BO
10
Po
wit
the
(Fig
TO
11
12.
HO
It is
rec
13
14.
* T
le
1
(C
• A
w
i
h
1
• W
r
s
t
• W
u
• P
• D
r
• T
8