EINHELL GE-PM 51 VS-H B&S Mode D'emploi D'origine page 23

Anleitung_GE_PM_51_VS_H_BS_SPK7__ 07.08.13 13:22 Seite 23
any rotating parts. Keep clear of the chute
opening at all times.
17. Never lift or carry a lawn mower with the engine
running.
18. Switch off the engine and pull the spark plug
boot; Make sure that all moving parts have come
to a complete standstill:
- before you dislodge any blockages or clogs in
the chute.
- before carrying out any checks, cleaning,
maintenance or other work on the lawn mower
- if the lawn mower strikes a foreign body,
examine it for signs of damage and carry out any
necessary repairs before restarting and
continuing to work with the mower. If the lawn
mower begins to experience exceptionally strong
vibrations, immediately switch it off and check it.
19. Switch off the engine; Make sure that all moving
parts have come to a complete standstill:
- when you leave the lawn mower.
- before you refuel.
20. Operation of the machine at higher than normal
speed can lead to an increased risk of accidents.
21. Take care when carrying out installation work on
the machine, and avoid trapping fingers between
the moving cutting tool and the fixed parts of the
machine.
Maintenance and storage
1. Make sure that all nuts, bolts and screws are
tightened securely and that the machine is in
safe working condition.
2. Never store the mower (with petrol in the tank)
inside a building in which petrol fumes could
come into contact with open flames or sparks.
3. Allow the motor to cool before you put the lawn
mower in an enclosed area.
4. In order to avoid fire hazards, keep the engine,
exhaust and the area around the fuel tank free
from grass, leaves and leaking grease (oil).
5. Routinely check the grass basket for signs of
wear and impaired functionality.
6. For your own safety, replace worn or damaged
parts without delay.
7. If the fuel tank should require emptying this
should only be done in the open air using a
petrol suction pump (available from DIY shops).
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Explanation of the symbols on the machine
(fig. 24):
1) Read the operating instructions
2) Important! Danger from catapulted parts. Keep a
safe distance.
3) Important! Switch off the engine and pull the
spark plug boot before doing any maintenance,
repair, cleaning or adjustment work.
4) Fill with oil and fuel before starting the mower.
5) Caution! Wear ear protection and safety goggles.
6) Engine start/stop lever (I=Engine on; 0=Engine
off)
7) Drive lever (clutch lever)
8) Risk of cut injuries. Caution: rotating cutters.
9) Empty the tank before you move the mower into
cleaning position.
10) Starting procedure
11) Guaranteed sound power level
2. Layout (Fig. 1-23)
1. Engine start/stop lever – engine brake
2. Top push bar
3. Integrated carry handle
4. Starter cable
5. Lower push bar
6. Grass box filling level indicator
7. Grass basket
8. Ejector flap
9. Cutting height adjustment
10. Tank filler opening
11. Oil-filler neck
12. Spark plug connector
13. 2x cable clips
14. Spark plug wrench
15. 2x quick-release fasteners for the bottom push
bar
16. 2x quick-release fasteners for the top push bar
with spring
17. Side ejector cover
18. Cleaning scraper
19. Drive lever (clutch lever)
20. Drive wheel (left and right)
21. Side ejector adaptor
GB
23