Yakima SkyBox Mode D'emploi page 5

CHECK iNSTallaTioN BEFoRE dRiViNG aWaY
make sure installation is
secure by tugging at box.
• The box should not slide
on the bars.
• Open the box and tighten
levers if necessary.
To lock...
• Turn key clockwise.
• To unlock, insert
key and turn key
counterclockwise.
NOTE: Box must be closed
and handle in horizontal
position in order to lock
box and remove key.
1034839B-5/18
CENTER HEaViER loadS iN
THE CENTER oF THE Box.
alWaYS SECuRE THE load
iNSidE THE Box.
Use tie-down locations in rails.
To replace lock core...
• Close box.
• Insert key and turn it to 45º
counter clockwise. Remove key.
• Insert control key
and remove core
with control key.
• Install new lock core.
Follow instructions
that came with your
lock core purchase.