Measuring Parameters - Ecolab MULTRONIC Manuel Technique

The max. metering time function is used to specify the period of time during which the
controller may meter uninterrupted before the alarm message 'metering time exceed'
appears and the controller is turned off. This alarm message can be acknowledged with
ENTER. The controller then resumes operating until the metering time may be exceeded
again. The metering time monitoring function of other possible controllers also remains
unaffected if an alarm is indicated. Where required, these are also turned off once they
have reached their max. metering time.
Value range: 10 sec to 9999 sec
The metering time monitoring function can be turned off with the Off setting.
NOTE
Through selecting the module selection function one returns to configuration module
selection.
The first page of the conductive C module configuration menu is opened through
selecting page 1.
4.2

Measuring parameters

The main menu for adjusting the Multronic is accessed through operating the ↑ key in
the measuring mask.
Main menu
The measurement parameters are selected through placing the cursor onto the selected
item and operating the ENTER key.
Measurement
parameter module
selection
(not available at
Multronic OC!)
The conductive C-measuring module that is to be parametered can now be selected. To
do so, move the cursor onto the corresponding selected item and operate the ENTER
key.
417101802_Anhang02_LF_konduktiv.doc
Conductivity Measuring Module (contact measurement)
The time periods for the controllers must be within realistic limits.
min. controller on-time < controller cycle time < max. metering time
- 34 - Rev.: 05-07/10