Additional Information; Troubleshooting; General - Yamaha CRX-332 Mode D'emploi

Masquer les pouces Voir aussi pour CRX-332:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20

ADDITIONAL INFORMATION

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.

General

Problem
This unit fails to turn
The power cable is not connected or the
on or enters the
plug is not completely inserted.
standby mode soon
This unit has been exposed to a strong
after the power is
external electric shock (such as lightning
turned on.
or strong static electricity).
The unit does not
operate properly.
No sound.
No appropriate input source has been
selected.
Speaker connections are not secure.
The mute function may be on.
The volume is turned down.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
The power is
The sleep timer may be set.
suddenly turned off.
The unit is left turned on for 1 hour
without playback or any other operation
being performed.
AUTO POWER OFF is triggered.
Sound is heard from
Incorrect cable connections.
the speaker on one
side only.
There is noise
This unit is too close to the digital or
interference from
high-frequency equipment.
digital or radio
frequency
equipment.

TROUBLESHOOTING

Cause
Connect the power cable firmly.
Press and hold
the system. If this does not solve the problem, set this
unit to the standby mode, disconnect the power
cable, plug it back in after 30 seconds and then use it
normally.
Select an appropriate input source with INPUT on
the front panel (or the source buttons on the remote
control).
Secure the connections.
Cancel the mute function.
Turn up the volume.
Play a source whose signals can be reproduced by
this unit.
This is not malfunction. Turn on the unit and play the
source again.
Setting AUTO POWER OFF to TIME OFF enables
to play continuously.
Connect the cables properly. If the problem persists,
the cables may be defective.
Move this unit farther away from such equipment.
Remedy
for more than 5 seconds to reset
Page
5
4
6
8
3
12
4
13
En

Publicité

Table des Matières
loading

Table des Matières