Skytec TEC 350 Mode D'emploi page 8

Different ways of connecting the combined microphone input
If you want to use the XLR input unbalanced, connect the centre pin to the ground
FUNCTIONS
Front Panel
1. POWER
2. INPUT SELECTOR
3. TREBLE
4. BASS
5. CHANNEL
6. MICROPHONE
7. MIC LEVEL
8. TALKOVER
9. VU-METER
10. MASTER
11. ASSIGN
12. CROSSFADER
13. CUE SELECT
14. PFL LEVEL
15. HEADPHONE
Rear Panel
16. EARTH
17. REC
18. MASTER
19/21 CHANNEL PHONO & LINE
20. MIC
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings
contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations and
warnings. This is also applicable to all damages in whatever form.
On/Off switch
(4x) Selects the input signal for both channels
(4x) Treble control for both channels
(4x) Bass control for both channels
(4x) Slider controls for the volume of both channels
6.3mm/XLR combi jack for a microphone
Setting of the microphone output level
Switch that attenuates the sound of every channel when the
mic is used
Displays the strength of the output signal
Master control for the volume of the output signal
Channel selection knob for the crossfader function
Fast fading between the channels
Selects the channel to be heard through the headphones
Sets the volume to the microphone output
6.3mm Jack socket for the headphones
Earth connector for the ground wire from the turntables
RCA sockets for connection to a recorder
RCA sockets to the amplifier
RCA sockets for connection to a PHONO or LINE (CD player,
tuner, etc.) for the different channels
6.3mm Jack connector for the microphone
1 = Ground
2 = + ( Live)
3 = - ( Return )