Skytec TEC 350 Mode D'emploi page 6

Congratulations on the purchase of this SkyTec mixer.
Please read this manual carefully prior to using the unit.
Warning
:
- Read the manual prior to using the unit.
- Keep the manual for future reference.
- Keep the packaging for safer transport in its original packaging
- For indoor use only.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the mixer.
- When you unplug the unit from the mains always pull the plug, never the lead.
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a
mains outlet.
- Repairs and lamp replacement has to be carried out by a qualified technician.
- Only connect this unit to an earthed mains outlet of 230Vac/50Hz and 10-16A.
- Do no place the unit near heat sources.
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the
housing. Please let the unit reach room temperature prior to use.
- Keep out of the reach of children.
- All channel controls and the master volume control must be set to zero prior to switching the
unit on.
- To prevent clipping of the amplifier do not set the volume level too high.
- Switch the amplifier on at latest and switch it off at first.
- Do not use cleaning sprays for the slider controls. The residues of these spray cause dust
deposits in the controls. If a problem occurs, please consult a specialist.
General description
The professional stereo mixer TEC 350 features 5 separate input channels of which 2 are convenient
for microphones. A slider control with a LED vu-meter on the MASTER output ensures an accurate
setting of the signal level to the amplifier. The built-in stereo headphone amplifier with volume control
can be set to any input channel and to the MASTER output. The unit is convenient for rack mounting
or free-standing. For indoor use only. Do not attempt to repair the unit yourself. Repairs should only be
carried out by a qualified technician. The only user serviceable part is the crossfader.
The unit is powered from 230Vac and MUST BE EARTHED
GB
.