SOLIS ULTRASONIC HYBRID 7214 Mode D'emploi page 67

4 . T UR NI N G O F F T H E A PP L IA N CE
– Turn off the appliance with the ON/OFF switch.
– Pull the power plug from the socket.
– Remove the water tank from the base and open the cap. Pour out the water and
rinse the tank.
– Let all parts dry and store away the appliance.
5 . A UT O M AT IC SH U TD O WN W H EN WAT E R T ANK IS EMP T Y
• When the water tank is empty an acoustic signal will sound, the corresponding
symbol will light up in the display and the appliance will automatically stop hu-
midifying. In this case, turn off the appliance with the ON/OFF switch and pull
the power plug from the socket. Let the appliance cool down before pouring
in any more water (see page 65).
• CAUTION: The appliance and the water in the nebulisation chamber might
be very hot. When lifting the appliance or removing the water tank right after
operation you risk scalding yourself with the hot water!
• Ensure that the water tank is always completely reilled.
6 . AUTOMATIC SHUTDOWN WHEN TEMPERATURES
ARE TOO HIGH
• When the nebulisation chamber is overilled or empty or when the air humidiier
has not been operated properly, overheating protection is activated. An acoustic
signal will sound and the display will state „High Temp.". The appliance will
automatically stop humidifying and shut down completely.
In this case, pull the power plug from the socket and let the appliance cool
down. Empty out the water in the nebulisation chamber and completely reill
the tank. The appliance should be operational again. Should this not be the case,
the water level sensor might be damaged. Please bring your air humidiier to a
SOLIS service centre.
• CAUTION: The appliance and the water in the nebulisation chamber might
be very hot. When lifting the appliance or removing the water tank right after
operation you risk scalding yourself with the hot water!
67