Setting The Status Of The 2-Way Valve In Cooling Mode (Cool 2-Way Valve); Setting The Status Of The 2-Way Valve In Heating Mode (Heat 2-Way Valve); Setting Solar System Integration (Solar Setting) - Olimpia splendid SHERPA MONOBLOC S1 E 6 Mode D'emploi Et D'entretien

7.3.

Setting the status of the 2-way valve in cooling mode (Cool 2-Way valve)

After accessing the "Cool 2-Way valve" function, you
can set the status of the 2-way valve in cooling mode
(for more information about the assembly and use of
the 2-way valve, refer to the installation manual). Se-
lect the required logic, then press "OK" to confirm.
NOTES:
1. If you select the "Off" status, the valve will be CLOSED in cooling mode; it will be OPEN if you select
"On".
2. If the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
7.4.

Setting the status of the 2-way valve in heating mode (Heat 2-Way valve)

After accessing the "Heat 2-Way valve" function, you
can set the status of the 2-way valve in heating mode
(for more information about the assembly and use of
the 2-way valve, refer to the installation manual). Se-
lect the required logic, then press "OK" to confirm.
NOTES:
1. If you select the "Off" status, the valve will be CLOSED in heating mode; it will be OPEN if you select
"On".
2. If the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
7.5.

Setting solar system integration (Solar setting)

Function currently NOT AVAILABLE.
WARNING: this function is not currently available, so its setting must necessarily be "Without".
26
Cool 2 way valve
Off
On
OK
Heat 2 way valve
Off
On
OK
Cancel
Cancel