Publicité
Les langues disponibles
Les langues disponibles
4.14.
Setting the winter period absence function (Holiday mode)
You can use the weekly timer to assign the "Holiday"
program to at least one day of the week. On those
days, the unit will work in heating mode, maintaining
a 30°C set-point on delivery water (or 10°C if the check
is based on the ambient air). To enable the implemen-
tation of the Holiday Program (if set on the weekly
timer), you must activate this function.
After accessing the "Holiday mode" function, you can
choose one of the modes available by clicking directly
on the text that identifies it and then confirming with
the "OK" key.
NOTES:
1.
Before changing the operating mode, the unit must be OFF, otherwise a message will warn you to
turn the unit off before changing the mode.
2.
During the use of Holiday mode (as set in the weekly timer), the operating mode will be automatical-
ly set on "Heating" and the On/Off command from the panel cannot be used.
3.
None of the functions linked to the timers will be available during Holiday mode.
4.
Certain functions are not available in Emergency mode so, if you attempt to activate them, the sys-
tem will tell you to disable Emergency mode first.
5.
If the relative function is activated (paragraph 8.3), the value of this parameter will be stored in the
memory and automatically reset after any possible voltage failure.
6.
The default value for this function is "Off".
4.15.
Setting the daily timer programming (Preset mode)
This function is used to set one to four daily periods,
whose commands will then be executed every day.
After accessing the "Preset mode" function, you can
press the key for each period to activate or deactivate
an individual period, choose the operating mode to
be used, the temperature set-point for processed wa-
ter, and the start and end times of the period itself.
Clicking on the "Period" label will open the page with
the labels relating to period activation, the mode to
be used during the period, the water delivery tem-
perature and the start and end times. Click on each of
these to set the appropriate value (each data item may
draw up additional windows for selecting or entering
the required values). Lastly, press the top right button
to save the data entered.
NOTES:
1.
If the water tank for this model is not installed (and correctly set), Hot water mode will not be
available.
2.
If timer programming with the Weekly timer and other settings with Preset mode have been entered
Holiday mode
Off
On
OK
Preset mode
Period 1: Valid
Period 2: Invalid
Period 3: Invalid
Period 4: Invalid
Preset mode
Period 1: Valid
Mode: Heat
WOT Heat: 45°C
Start timer: 00:00
End timer: 00:00
Cancel
19
Publicité
Chapitres
