Publicité
Les langues disponibles
Les langues disponibles
6.4.
Viewing the active errors on the unit (Error)
These pages display the current errors and alarms active on the unit. After accessing the "Error" function,
you can browse any pages using the buttons on the left and right sides of the window.
NOTES:
1.
This function does not allow current errors to be reset; it only displays them.
2.
For more information about the error codes, refer to chapter 9.
3.
There may be several pages, depending on the number of errors (up to 5 errors per page).
6.5.
Viewing the error log (Error log)
These pages display the alarm log for the unit. After accessing the "Error" function, you can browse any
pages using the buttons on the left and right sides of the window.
NOTES:
1.
There may be several pages, depending on the number of errors; the log lists the last 20 errors.
2.
For more information about the error codes, refer to chapter 9.
6.6.
Viewing software information (Version)
These pages display the version of the software installed on the unit.
7.
COMMISSION MENU
7.1.
Navigating the menu
WARNING: these functions and parameters must
only be set and/or modified by authorised person-
nel with the necessary technical skills to install and
maintain these units.
Incorrect settings may lead to malfunctioning or
damage to the unit and the system!
This menu is used to make the settings needed for
correct unit operation: the logics, the components in-
stalled on the system and the accessories envisaged
for each installation will be set using the functions in
this menu.
The information in the menu is sub-divided into two
large macro groups:
"Function" (containing the settings and any
functions needed for unit operation)
"Parameter" (containing the general operating
parameters)
24
Commission
Function
Param.
Publicité
Chapitres
